The Hybrid Chopper® of Van der Mast is developed and made for chopping non breakable fibers, like Polymers and Natural fibers. There are two versions which both make a sliding cut, the HC and HC+. Last mentioned is mainly used for Polymers with low denier like Aramid, Dyneema, etc. The HC+ can unlike many other choppers also cut natural fibers with a 100% cut
Below you find the machines that use this technology. Choose the type that fits your requirements.
Chopcot® HC
The Chopcot HC is best suited for
- Fiber: Polymers (Specific Polysteel: PolyPropylene and PolyEthylene (PP/PE) twisted into twine)
- Industry: Automotive & Aerospace, Construction
- Capacity: Mid-range
Chopcot® HC+
The Chopcot HC+ is best suited for
- Fiber: Polymers (Aramid, Dyneema, Thermoplastics (PP/PA/PE), etc.), Natural (no sizing required)
- Industry: Automotive & Aerospace, Construction, Textile, Consumer products
- Capacity: Mid-range
tOOchop® SK
The Chopcot SK is best suited for
- Fiber: Polymers (Aramid, Dyneema, Thermoplastics (PP/PA/PE), etc.), Glass, Steel
- Industry: Automotive & Aerospace, Textile, Consumer products
- Capacity: Low & Mid-range